Crossbeam - XOS - CPM - View Route Table - CLI

IP route table of Crossbeam CPM can be viewed using command "show ip route". The command display both IPv4 & IPv6 route table. The below example is from a Crossbeam appliance running XOS 9.0.3 operating system.

Syntax:

show ip route

Example:

Crossbeam-XOS-CPM# show ip route
 
Route table:
Module           Destination        Gateway         Metric  Device
APM_1            10.151.6.200/32    10.101.53.1     0       mgmt
APM_1            10.101.53.0/24     0.0.0.0         0       mgmt
APM_1            192.168.1.0/24     0.0.0.0         0       sync
APM_1            1.1.1.0/24         0.0.0.0         0       eth0
APM_2            10.151.6.200/32    10.101.53.1     0       mgmt
APM_2            10.103.54.0/24     0.0.0.0         0       mgmt
APM_2            192.168.1.0/24     0.0.0.0         0       sync
APM_2            1.1.1.0/24         0.0.0.0         0       eth0
primarycpm       10.101.53.0/24     0.0.0.0         0       eth2
primarycpm       1.1.0.0/16         0.0.0.0         0       eth0
primarycpm       168.254.0.0/16     0.0.0.0         0       eth2
primarycpm       0.0.0.0/0          10.101.53.1     0       eth2
 
IPv6 Route table:

Crossbeam-XOS-CPM#