Check Point - GAiA - View SNMP Configuration - CLI

SNMP configuration of a Check Point - GAiA device can be viewed using command "show configuration snmp".

Syntax:

show configuration snmp

Example:

CP-GAiA-FW> show configuration snmp
set snmp agent on
set snmp agent-version any
set snmp community mysnmp read-only
add snmp address <xx.xx.xx.xx>
add snmp traps receiver <yy.yy.yy.yy> community <snmp-community> version v2
add snmp usm user snmp-user security-level authNoPriv auth-pass-phrase-hashed 60a1f34c167b57aff9ac8ee05597
set snmp traps trap authorizationError enable
set snmp traps trap coldStart enable
set snmp traps trap configurationChange enable
set snmp traps trap configurationSave enable
set snmp traps trap fanFailure enable
set snmp traps trap highVoltage enable
set snmp traps trap linkUpLinkDown enable
set snmp traps trap lowDiskSpace enable
set snmp traps trap lowVoltage enable
set snmp traps trap overTemperature enable
set snmp traps trap powerSupplyFailure enable
set snmp traps trap raidVolumeState enable
set snmp traps polling-frequency 5
set snmp traps trap-user snmp-user
set snmp contact "snmp-admin"
set snmp location "Washington Data Center"
CP-GAiA-FW>
CP-GAiA-FW>