Check Point - ClusterXL Configuration and Troubleshooting and VRRP Command Reference

List of Check Point ClusterXL Configuration and Troubleshooting and VRRP commands.

Command	Description
cphaprob state	View HA state of all cluster members.
cphaprob -a if	View interface status and CCP state.
cphaprob -ia list	View list and state of critical cluster devices.
fw hastat	View HA state of local machine.
cp_conf ha enable|disable [norestart]	Enable or disable HA.
cphastart cphastop	Enable / Disable ClusterXL on the cluster member. On HA Legacy Mode cphastop might stop the entire cluster.
cphaprob syncstat	View sync transport layer statistics. Reset with -reset.
fw ctl pstat	View sync status and packet statistics.
fw ctl setsync <off|start>	Stop or start synchronization in a cluster.
fw -d fullsync <member-ip>	Start a full synchronization with debugging output.
cphaconf set_ccp <broadcast|multicast>	Configure Cluster Control Protocol (CCP) to use unicast or multicast messages. By default set to multicast.
cphaconf debug_data	View multicast MAC addresses used.
clusterXL_admin [-p] <up|down>	Perform a graceful manual failover by registering a faildevice. Survives a reboot with -p switch set.
show vrrp interfaces	Detailed status of VRRP interfaces. For a brief overview you can also use show vrrp in the iclid shell.
cphaprob tablestat	View IPs and interface IDs for all cluster members.
cphaprob igmp	View IGMP status for CCP multicast mode.