Check Point - GAiA - How To View Management Interface And Its Details - CLI

In Check Point GAiA system, management interface can be viewed using command "show management interface". Configuration and details of management interface can be viewed using command "show interface [management interface name]".

The command need to be executed on clish mode.

Syntax:

show management interface
show interface [management interface name]

Example:

CheckPoint-GAiA> show management interface
 Mgmt
CheckPoint-GAiA>

CheckPoint-GAiA> show interface Mgmt
state                                  on
mac-addr                            00:1c:cc:cc:cc:dcc
type                                ethernet
link-state                          link up
mtu                                  1500
auto-negotiation                       on
speed                               1000M
ipv6-autoconfig                     Not configured
duplex                               full
monitor-mode                        Not configured
link-speed                          1000M/full
comments
ipv4-address                        10.30.30.46/24
ipv6-address                        Not Configured
ipv6-local-link-address             Not Configured

Statistics:
TX                                  bytes:160056685071 packets:134799492 errors:0 dropped:0 overruns:0 carrier:0
RX                                  bytes:6299169269 packets:80242904 errors:60 dropped:0 overruns:0 frame:0
CheckPoint-GAiA>