Check Point - GAiA - How To View All Interfaces And Interface Details - CLI

In Check Point GAiA system, list of all interfaces can be viewed using command "show interfaces" and details of a specific interface can be viewed using command "show interface [interface name]".

The command need to be executed on clish mode.

Syntax:

show interfaces
show interface [interface name]

Example:

CheckPoint-GAiA> show interfaces
 Mgmt
 Sync
eth1-01
eth1-02
eth1-03
   lo
CheckPoint-GAiA>

CheckPoint-GAiA> show interface eth1-01
state                                  on
mac-addr                            00:1c:ff:ff:ff
type                                 vlan
link-state                          not available
mtu                                  1500
auto-negotiation                    on (eth1-01)
speed                               10G (eth1-01)
ipv6-autoconfig                     Not configured
duplex                              full (eth1-01)
monitor-mode                        Not configured
link-speed                          10G/full (eth3-02)
comments                            {Internal interface}
ipv4-address                        10.10.10.226/29
ipv6-address                        Not Configured
ipv6-local-link-address             Not Configured

Statistics:
TX                                  bytes:167817984809382 packets:236882592445 errors:0 dropped:0 overruns:0 carrier:0
RX                                  bytes:74310939553031 packets:196162288225 errors:0 dropped:0 overruns:0 frame:0
CheckPoint-GAiA>